您当前的位置：
首页 >
文章列表页 >
Influence of Projectile Material on Overflow Water-Projectile Assisted Injection Molding Pipes
更新时间：2024-01-31

    • Influence of Projectile Material on Overflow Water-Projectile Assisted Injection Molding Pipes

    • Engineering Plastics Application   Issue 5, (2021)

    • DOI：10.3969/j.issn.1001-3539.2021.05.0017    

      CLC：

    • Published：2021

    移动端阅览

  • Hu Libin, Kuang Tangqing, Lai Jiamei, et al. Influence of Projectile Material on Overflow Water-Projectile Assisted Injection Molding Pipes[J]. Engineering Plastics Application, 2021, (5). DOI： 10.3969/j.issn.1001-3539.2021.05.0017.

  •  
  •  

0

Views

2

下载量

3

CSCD

Alert me when the article has been cited
提交
Tools
Download
Export Citation
Share
Add to favorites
Add to my album

Related Articles

Residual wall thickness and its distribution optimization in water-assisted injection-molded square pipe fittings
Application Progress of Frontal Polymerization on Synthesis and Preparation of Polymer Materials
Analysis of Typical Defects in Automobile Injection Parts and Solving Measures
Hardware-in-the-loop test for a braking system of pressure individual regulation
Modal control of smart constrained layer damping plate based on state observer

Related Author

JIANG Qingsong
LIU Linhai
LIU Hesheng
ZHANG Wei
Li Xuyang
Guo Meng
Liu Qiuju
Gao Longna

Related Institution

School of Electronics and Electrical Engineering (School of Intelligent Manufacturing)，East China University of Technology
School of Mechatronics and Vehicle Engineering，East China Jiaotong University
Key Lab of Polymer Science & Nanotechnology, Henan University of Science and Technology, Luoyang
Research and Development Center, National Engineering Laboratory for Plastic Modification and Processing, Kingfa Science and Technology Co. Ltd., Guangzhou
0