您当前的位置：
首页 >
文章列表页 >
Design of Large and Thin-Walled Parts and the Treatment of Injection Defects
更新时间：2024-01-31

    • Design of Large and Thin-Walled Parts and the Treatment of Injection Defects

    • Engineering Plastics Application   Issue 9, (2019)

    • DOI：10.3969/j.issn.1001-3539.2019.09.018    

      CLC：

    • Published：2019

    移动端阅览

  • Sun Jinsheng, Meng Riliang, Chen Yongbing, et al. Design of Large and Thin-Walled Parts and the Treatment of Injection Defects[J]. Engineering Plastics Application, 2019, (9). DOI： 10.3969/j.issn.1001-3539.2019.09.018.

  •  
  •  

0

Views

1

下载量

0

CSCD

Alert me when the article has been cited
提交
Tools
Download
Export Citation
Share
Add to favorites
Add to my album

Related Articles

Control System Design of Winding Machine Based on CADFIL and NUM
Precision Injection Mould Design of Siemens Electrical Switch
Injection Mould Design of Auto Plastic Part "Four Claw Clip"
Review on Aligned Design and Fabrication of CNTs/Fiber Reinforced Composites
Design and Processing Technology for Injection Mould of Automobile Intake Manifold's Lower Shell

Related Author

Zhou Mingyi
Yang Honghong
Gao Liye
Wang Rongguo
Xu Jiazhong
Wu Lingfang
Wang Fang
Song Xiaohui

Related Institution

Harbin Institute of Technology, Harbin
2. Harbin University of Science and Technology, Harbin
3. Department of Mobile Engineering, Guilin University of Aerospace Technology, Guilin
2. Department of Mechanical and Power Engineering, Nanchang Institution of Technology, Nanchang
Department of Mechanical Engineering, Guilin University of Aerospace Technology, Guilin
0